OWNER’S GUIDE
Page 16
Figure 19. Front Pebble
Location
Figure 18. Ceramic Base Pebble Location
FUEL BED REFITIING - PEBBLES
This section is for models supplied with a ‘Pebble’ effect fuel bed only.
For ‘Coal’ see section headed
‘ Fuel Bed Refitiing – Coal’.
If the fuel bed components are
dislodged or removed, they must
be refitted as follows:
Only the fuel bed parts supplied
with this appliance or authorised
Valor replacements must be
used. Never add extra Pebbles
above the number stated in these
instructions.
1.
Place the ceramic pebble base
in the burner compartment. The
bottom rear face of the pebble
base should rest on the angled
ledge at the back of the burner
tray.
The bottom front lower edge of the
pebble base should locate against the step in
the burner plaques.
The front edges of the
pebble base should not come into contact with
the metal brackets to the side of the burner
tray
(See figure 18).
2.
Place the left-hand ceramic front pebbles in
position in front of the base pebbles (See
figure 19).
3.
Place the right hand ceramic front pebbles
in position in front of the base pebbles. This
should join with the left-hand pebbles. Push
the two sides together to minimise the gap.
(See figure 19).
4.
There will be a gap between the rear of the
front pebbles and the front of the base pebbles.
(See figure 19).