4
Installation
1. Fit Bridging Baffle under the top panel of the
appliance case. Secure as shown with 2 thread
forming screws provided.
2. Locate and slide “rear” backing plate assembly to
firebox, and secure with 4 screws provided.
3. Proceed with the installation of the firebox, gas
fitting, venting, fuel bed and so on as per appliance
instruction manual.
At the time of installation of the ceramic or glass liner
panels in the appliance, install the roof grille supplied
with the kit as follows:
a. Insert the grille in the firebox by aligning one of its
side edge to the edge of the firebox as indicated.
b. Raise the grille up to cover the top firebox ports
and hold with one hand.
Note: The port cover strip supplied with the
heater is not required.
c. Place the rear brick wall. It should support the
grille. If not, keep holding it while you place the
side brick walls. Refer to the fireplace installation
manual for more information on installing the
brick walls.
4. Position and secure backing plate to frame assembly
using 9 screws provided.
Note:
As the painting process is automated and the
backing plate is symmetrical, ensure the prefered
finished side is visible to the homeowner.
Grille inserted
parallel to
firebox edge
