OWNER’S GUIDE
Page 7
Figure 2 Ultimate Controls
OPERATING YOUR FIRE
The pilot may be left alight. It is advisable, however, that the pilot is turned off if the
premises are to be left unoccupied for a lengthy period.
For your safety the fire is fitted with a flame supervision device which will shut off the
gas supply if for any reason the pilot goes out. This device incorporates a fixed probe
which senses the heat from the pilot flame. If the probe is cool the device will prevent
any gas flow unless the pilot lighting knob is held in. This device also stops the fire being
turned back on until it is safe after it has been turned off.
If, for any reason, the fire goes out or if the fire is turned off, always
wait at least three
minutes before attempting to relight
If the device starts to shut off the gas
frequently, get expert advice.
Model 5400 Ultimate
The controls are shown in figure 2.
To light the pilot
•
Push in the right control knob (the pilot
lighting knob) and, while keeping it depressed,
turn anticlockwise through the ignition position
marked and up to the pilot position
marked . The spark should light the pilot. The pilot flame can be seen by looking
through the gap near the left side of the coal front (See figure 4).
•
When the pilot has lit, keep the right hand control knob depressed for a few seconds to
prevent the flame supervision device from shutting off the gas supply while its probe
warms up, as explained above, then release it. If the pilot does not remain alight turn the
knob back to the off position marked
•
.
Wait a few seconds and repeat the lighting
sequence.
To Light the Main Burner
•
Partially depress the right control knob and turn to the main burner position marked
The main burner should now light at its low position.
•
The left-hand knob is for burner flame adjustment. Turning it anticlockwise should
gradually increase the flame height and heat output. Turning clockwise reduces the flame
height and heat output.
•
The burner flame control does not have to be re-set every time the fire is lit. Once set,
it can be left at that position allowing you to use the right hand control only to ignite the
burner at the set flame height.
To Turn Off the Main Burner Only
•
Turn the right hand control knob to the pilot position marked .
