7.9.
Attaching Rear Ceramic Support
Fit the rear ceramic support to the firebox back
panel with three screws. See figure 30.
7.10.
Attaching to the Framing
1.
Place the heater in position in the framing.
2.
Secure the side support angles to the side studding through two holes each side with the woodscrews supplied. The top
support angle should abut the wall finish but is not fixed to the framing.
3.
Check the wall finish requirements with the homeowner. If necessary, adjust the position of the heater so that the
distance from the front of the heater case to the angles is suitable for the thickness of the wall finish (e.g. tile, etc.) – see
Figure 30 Rear ceramic support
Figure 31 Adjustment for wall finish
Summary of Contents for 534AN
Page 16: ...16 Figure 19 Pack contents...
