8 of 18
B-Vent Conversion Kit Installation
i.
Fit adapter unit
1.
Remove the rear outlet vent collar and seal by unscrewing 12
screws (See figure 5).
2.
Fit the rear cover plate (supplied with the kit) using the seal and
12 screws previously removed. The hole in the cover plate must
be nearest the top edge (See figure 6).
3.
Remove 4 screws from the case back (2 each side just outside
of the cover plate). Fit the adapter unit to the case using these
screws (See figure 7).
4.
Fit a “P” clip at the bottom rear right
corner of the appliance case. Fit the vent
switch wire to the clip (See figure 8).
Feed the wire into the case through the
hole at the bottom corner.
Figure 8
Figure 7
Figure 6
Figure 5