58
Installation
Sides of grate: do not overfi ll
cavity to leave space under
grate’s left and right supports
for airfl ow
top view of burner
slots for grate’s tabs
NG
LPG
Install Traditional Log Kit 1400LSK
Material required
• Log set containing:
•
1 grate
•
7 logs
•
2 bags of loose coal pieces
• Gloves, if desired
Installation
Unpack the ceramic logs very carefully to avoid
damaging them. Install the logs as shown below.
Please note that
the position of the logs is critical to
insure proper performance of the appliance.
1. Place the grate securing it by inserting the tabs in
the slots at the front edge in the burner platform
cavity. Center the grate with the burner cavity.
2. Cover the burner cavity with loose coal pieces as
shown. A single layer of coals is all that is required.
Remaining coals can be used later on (step 10) out-
side the burner cavity to hide driftwood log location
pin holes in burner.
Note:
Avoid piling coals against the sides of the
grate to allow air fl ow under the grate.
3. Place the right rear log inserting the grate’s right
side support into the slot on the underside of the log
and resting the log’s end on the rear middle tine of
the grate as indicated.
Note:
This gap between the log and
the front inside edge of the grate
depends of the gas type used.
NG = 1” LPG = 1-3/4”
QUALIFIED
INSTALLER
