2
Install Wall Switch Kit (recommended)
The wall switch is connected to the receiver in the
fireplace.
Note:
You must complete the installation of the wall
switch, connect the battery holder, and test the wall
switch
before
synching the handset to the receiver. See
your fireplace’s installation instructions for details.
1. If connected, disconnect the battery holder from the
receiver.
2. Decide where the switch is to be installed in the
wall. Install an electrical outlet box or mud ring as
required (not supplied).
3. Thread the switch wire through an access hole in
the appliance toward the outlet box. The brown end
stays in the engine, the black end goes out to the
wall switch.
4. Pull out the receiver. You can remove the ignition
wire to improve access to the receiver.
5. Take the switch wire and plug the brown connector
into the receiver’s connection slot as indicated (the
other slot should already be fitted with the valve’s
wire harness connector). See diagram at right.
IMPORTANT: The connection can only be fitted one
way. Do not force it or damage the pins!
6. On the outside of the fireplace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
7. Plug the black end of the wire into the switch plate
connector.
8. Screw the switch plate into the installed outlet box.
9. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES NOT
TOUCH the receiver’s antenna.
10. Connect the battery holder to the receiver.
IMPORTANT: The connection can
only be done one way.
Do not force it or damage the pins
on the receiver box!
11. Test the wall switch’s operation — see page 1.
12. Once operation is confirmed correct, fix the wall
cover plate to the outlet box.
13. Replace the receiver in its position, as well as the
antenna if deployed.
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstalling not to bend or break
the spade connector
Ignition Wire
Antenna
Valve Wire
Harness
Wall Switch Harness
Battery holder cable
(disconnected)
Caution
DO NOT PUT BATTERIES IN THE REMOTE CONTROL
RECEIVER!
Caution
DO NOT RUN the switch wire over top of firebox.
Route wire so it does not contact firebox.
Caution
To avoid short-circuit to receiver, position
antenna so that it DOES NOT TOUCH ignition wire.
Caution
DO NOT USE screwdriver or other metallic object
to remove batteries from receiver or handset!
This could cause a short-circuit to receiver.