2.
Supplied with the heater is a
lower securing bracket (See
figure 1). Offer one side of the
bracket into the slot at the rear
base of the heater (See figure
7). Swing the opposite side into
place, until the bracket is
horizontal, then pull down to hold
in place (See figure 7). The
bracket will remain loose but
should not fall out of place.
Fitting the cover plate.
The heater is supplied with a cover
plate for the base of the heater (See
figure 1).
1.
Secure the cover plate to the base
of the heater using two No.8 x 3/8
screws supplied (See figure 8).
Hanging the heater.
1.
Hang the heater body on the wall
hanging bracket. Ensure that the
heater is central.
2.
Underneath the heater, mark on
the wall the position of the hole in the
lower support bracket.
3.
Lift the heater off the wall.
4.
Drill the marked position using a
suitable sized masonry drill bit for the
wall plugs supplied.
5.
Insert a wall plug.
6.
Hang the heater body on the wall hanging bracket. Secure the bottom of the heater
using a woodscrew (See figure 1).
Page 12
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 7
Figure 8
Summary of Contents for 823
Page 20: ...Baxi Heating U K Limited 2008...
