4 ) Insert the TR1 damper into the TR1 Clamp from the bottom, until IT IS
within 8
"
of the center of the damper tube.
(See Figure 4)
(Note: Be sure that you insert the TR1 Damper into the TR1 Clamp taking note
of the direction indicated on the sticker of the Damper, as shown in figure 4.)
b)
Tighten set screw above the Valmont
®
“V” to snug, then an additional
1/4 turn.
Tighten all four socket head cap screws to hold the TR1 Damper in place,
making sure to maintain an even gap on both sides of the TR1 Clamp.
Tighten until snug, then an additional 1/2 turn of each screw.
CAUTION: Do not overtighten and ovalize the TR1 Damper tube. This will
cause the TR1 Damper to NOT function properly.
a)
Figure 4
This way
up
6
Summary of Contents for Mitigator TR1
Page 2: ......
