Vallox 096 MV, Manual

Page: 7 / 32

7
© Vallox Oy - All rights reserved
MOUNTING ON THE WALL
NOTE
Avoid mounting the unit on a hollow, echoing partition wall
or on a bedroom wall, or prevent the conduction of sound.
The minimum distance between the top of the unit and the
finished ceiling surface is 30 mm. Note that during mounting
the unit rises 10 mm higher than the final height.
Mount Vallox 096 MV, 110 MV, and Vallox 145 MV on the wall with a
mounting plate, as shown in the adjacent figure. Make sure that the
unit is horizontally level after mounting.
MOUNTING ON THE CEILING
Vallox 096 MV and Vallox 110 MV can be equipped with an optional
ceiling mount plate. To attach the ceiling mounting plate:
• On rafter frames or other frame structure with M8 thread bars
so that they withstand the weight of the unit.
• Ensure that the installation plate is horizontally level, as this
determines the position of the unit.
Insulate the outdoor air and exhaust air duct against condensation
also between the unit and the ceiling mounting plate.
Mounting the ceiling mounting plate
1. Fasten the thread bars on the rafter frames or other frame
structure, and screw the nuts onto the bars.
2. Lift the ceiling mounting plate in place.
3. Push a rubber damper and a washer onto each thread bar,
and ensure that they touch the bottom of the cups of the plate
(Vallox 096 MV).
4. Turn the nuts to make sure that the unit is horizontally level.
5. Shorten the lower ends of the thread bars so that they will be
at no more than 10 mm from the lower surface of the ceiling
mounting plate.
CAUTION
The ventilation unit is very heavy. Do not perform this
procedure alone.
INSTALLATION
INS
TALLA
TION
1
2
NOTE
When installing the
unit, reserve a sufficient
space in front of the unit
for servicing purposes.
Vallox 096 MV: The
service space in front of
the unit must be at least
400 mm.
Vallox 110 MV:
The service space in
front of the unit must be
at least 450 mm.
Vallox 145 MV:
The service space in
front of the unit must be
at least 550 mm.