OMNIA
35
6.5
MATERIAL PICK-UP ROLLER
The presser located on the top of the loader allows slightly deformed materials to be crushed so as not to cause false
readings to the “sheet ready” photocell.
Based on the thickness and stiffness of the materials, it can be adjusted in order to have a fair compromise between
the pressure on the material and the intervention height.
When using materials with a thickness greater than 3mm (0.012 "), loosen the knobs on the sides of the pressure bar
and lift the presser to the desired height (same height on both sides), then re-tighten the knobs.
Figure 6-5
6.6
DESCRIPTION OF SIGNAL LIGHTS
The machine is equipped with a light tower that provides the operators with some useful information as described
below:
Colour
Description
Figure 6-6
Constant red:
Warning:
Emergency buttons pressed; pressure on
safety mats; compressed air pressure is low;
disconnected auxiliary or thermal switches on the
electrical panel.
Flashing red:
Alarms reset, reactivate the machine by pressing the ON
button (Figure 6-2 A)
Rotating orange:
Waiting for PC connection
Constant green:
Work cycle in progress
Flashing green:
Cycle in pause programmed for operator intervention
Flashing orange:
• Cycle in unscheduled pause, operator intervention
required
• Sheet loss during loading cycle
Constant orange:
Manual loading and loader cycle start
Constant blue:
• Loading cycle start, missing sheets
• Loading cycle start, too many sheets on the loader
Flashing blue:
Reserve sheets loader
Another element that signals the adequacy of the air pressure is the oiler display (Figure 5-26) which, in addition to
displaying the instantaneous pressure, changes the color of the digits from green to red if the pressure falls below the
minimum required threshold.
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...