Valiani OMNIA, Instruction And Maintenance Manual

Page: 32 / 66

OMNIA
28
Depending on the material to be processed and its size, it may be appropriate to add an extension to the discharge
chute. Two extensions are supplied with the machine, you just need to insert them in front of the chute and lock them
with the relative knobs and washers.
5.7 ELECTRO/PNEUMATIC AND DATA CONNECTIONS.
Once the mechanical assembly has been completed, carry out the electro-pneumatic and data connections following
the steps listed below:
•
Loader electrical connection.
•
Electrical connection,
•
Power on and check.
•
Pneumatic connection.
•
Data connection.
5.7.1 LOADER ELECTRICAL CONNECTION
Open the machine panel by removing the 4 locking screws
Figure 5-21
Figure 5-22