SECTION III
-
CODES
& LIMITS
3-1 ENABLING BODY BUILDER, OHMS VALUE, AND UNIT COUNT
FUNCTIONS.
In order to enable the body-builder predictive equation
(To qualify as a “body-builder” that
person must be at least 20% above their ideal weight and that weight must be primarily
muscle mass)
1.
Step on platform
2.
When height flashes - Enter 8159 – then press the enter button
3.
Press, "Yes" to enable body builder mode and or "No" to disable-then press the
enter button (you won’t see anything change or light up) Next…
In order to enable the Ohms value to display on test reports:
1.
Remain on platform after enabling (yes) or disenabling (no) for “CO”
2.
Display shows “OH” for ohms
3.
Press “Yes” to enable or “No” to disable – then press the enter button. Next…
In order to enable the Unit Count number to display on test reports:
(This is available if you want to know exactly how many tests were administered.)
1.
Remain on platform after entering Ohms index enable or disable
2.
Weight window display shows “UC” for “Unit Count”
3.
Press “Yes” to enable or “No” to disable – then press the enter button
LED will now display the word “SET” in the far right hand weight display window.
Now step off the scale and allow it to reset. Once display has cleared, step back on the scale and
proceed as if doing a regular evaluation.
It is extremely important to disable the body-builder modifier after each measurement
where it has been enabled. If this is not reset, all measurements of “non body builder
subjects”will appear to be too low.
To remove body builder modifier repeat above-mentioned and press "NO" then enter. Continue
same procedure.
7
