- 10 -
SWITCHING OFF
Put the switch into pos. 0 and leave the tool to
cool down to room temperature before putting
it away.
MAINTENANCE
!
!
IMPORTANT! Always unplug the tool from
the mains socket and leave it to cool down
completely before proceeding with any sort
of inspection or maintenance jobs.
- Take good care of your tool and clean it regu-
larly. In this way its efficiency will be ensured
and its lifespan extended.
- Clean the tool using a soft cloth only.
- Do not wet or spray water over the tool.
- Do not use detergents or solvents to clean
the tool as you could irreparably damage it.
Chemical agents can easily damage the plastic
parts.
- Remove any processing residue from the tool.
TROUBLESHOOTING
Check that the plug is correctly plugged in to
the mains socket and that there is voltage in the
system. Put the switch into positions 1 and 2.
If the problem persists following these checks,
then the problem could be in the machine itself.
Have an authorised service centre check it out.
STORAGE
Follow the tips below to store the tool:
1) Ensure that the nozzle has cooled down
completely (to room temperature).
2) Clean the machine and all its accessories
thoroughly (see MAINTENANCE section).
3) Store it: out of reach of children; in a stable
and safe position; in a warm and dry place;
avoid excessively high or low temperatures.
4) Protect it from direct sunlight.
5) Do not seal it in nylon bags where humidity
could form.
6) Put the machine away in its container after
use.
DISPOSAL
In order to protect the environment, proceed accor-
ding to the local laws in force. Contact the relevant
authorities for more information.
When the machine is not longer useable or re-
pairable, deliver the machine and packaging to
a recycling centre. Take out the batteries (where
fitted) and dispose of them separately.
Electric and electronic waste may contain
substances that are dangerous for the envi-
ronment and for human health. For this reason
they must never be disposed of together with do-
mestic waste, but collected separately in specific
collection centres or returned to the retailer when
similar new equipment has been purchased. The
illegal disposal of such equipment may result in
prosecution to the full extent of the law.
WARRANTY
The product is protected by law against all non-
conformities with regard to its stated characte-
ristics, provided that it has been used solely in
the way described in this user’s instructions, it
has not been tampered with in any way, it has
been stored correctly, it has been repaired by
authorised personnel and, where necessary, only
original spare parts have been used.
In the event of industrial or professional use
or similar, the warranty is valid for 12 months.
To issue a request for intervention covered by
warranty, proof of purchase must be shown to
the retailer or authorised service centre.
