6. SINGLE MONITOR
CONNECTING AND DIAGRAM
Valet recommends that Valet 8 Intercom cable is used in the wiring of
its video intercom systems. The Valet 8 cable provides the appropriate
screened cable for both video and audio signals.
Connecting Cable to the Monitor Mounting Bracket PCB
1R: +12V Power supply positive for Door bell/camera
2W: GND Power supply ground for Door bell/camera
3Y: VIDEO Image signal transmitting line
4B: AUDIO Talk and control lines
When the connecting distance between monitor and Doorbell Camera
is over 50m, we suggest using RG-59 (3C-2V) co-axle cable to connect
3Y, 2W connecting terminals.
Connect the supplied 4 colour interface cable to JW-VP on the monitor
mounting bracket PCB. Then connect the other end to JS-VP on the rear
of the monitor (See GX-4P-2C3 below )
Connect the Power Supply Adapter
Note 1:
Door Release Timing. The standard setting for Door Release
signal is 1 second. Remove JP-LK jumper to increase time of signal to 3
seconds
Note 2:
Please Note: Any Door release
fi
tted must use its own matched
power supply and connects through LB on the VBC Plus Doorbell
Camera output.
7