Do not use this tool for work beyond its prescribed capacity. Do not apply excessive pressure or force the
tool. Do not drop or treat it roughly. Mishandling can weaken the insulation and other safety features.
Never lift the iron or hang the iron on hooks or nails by its cable as this may cause a short or damage the
cable.
Always use the right tool for the job and only for the purpose for which it was designed. Do not attempt to
adapt or modify a tool for an alternative purpose or gain a greater working capacity than that for which it
was intended.
Dress appropriately. Nonslip footwear is recommended. Wear protective hair covering to contain long hair.
Prior to operation, carefully inspect the tool for abnormalities and damage. Check for damaged parts, before
using the tool. Any part that is damaged should be carefully checked to ensure that it would operate
properly and perform its intended function.
There are no internally serviceable parts, do not attempt to disassemble.
Turn off the power supply and unplug the iron If you are leaving the iron unattended, vacating the work area
or in the event of an electrical failure.
Always operate the appliance in a well-ventilated area.
Do not allow the heat tip to be facing downwards for an extended period as this could cause heat issues with
the handle.
Soldering can be dangerous if safe and proper operating procedures are not followed. As with all tools, there
are certain hazards involved with the operation of this product. Using the tool with respect and caution will
considerably reduce the possibility of personal injury.
Operating Instructions
Prior to using the soldering iron, carry out the following checks
.
1.
Before switching on make sure the soldering tip is properly in position and the clamp screw is tight.
2.
Connect to an appropriate 230V mains outlet socket and switch the socket on (if applicable).
3.
The soldering tips must only be removed when the soldering iron is cool and disconnected from the
power supply. Loosen the clamping screw (fig. 1) and remove the soldering tip carefully, without using
unnecessary force. Insert the new bit fully into the iron and tighten the retaining screw.
4.
Do not heat up the soldering iron without the tip fitted.
5.
After use let the soldering iron cool down in the air (do not attempt to cool down using water or any
other liquid).
6.
When in use always place the soldering iron on its work stand for safe storage.
Soldering:
Soldering is a process for joining two metals’ together by the application of a molten material. Nearly all
metals and metal alloys, brass, copper iron, etc. can be soldered. Solder is generally made of Tin, but can
include small amounts of Lead.
Working temperature
Soldering at the correct temperature is very important to ensure perfect solder connection. If the
temperature is too low , the solder will not flow correctly and will cause cold solder joints. If the
temperature is too high, the flux will be burned and not allow the solder to flow. High temperature can also
cause damage to the PC Board and other sensitive components. When the tip working temperature is set
within the correct parameters suited to the particular solder being used a good joint is assured.
