Valeo TM08, Service Manual

Page: 38 / 56

-36-
6-Service procedures - Magnetic clutch
Drive plate holder
597031-2600
Drive plate puller
597032-2621
Snap ring
Pulley puller
(597033-1000)
Center pulley puller
597033-1700
External snap ring
pliers
Magnetic clutch
Removal
1. Remove the center bolt using the drive plate
holder (597031-2600) to prevent armature
assembly rotation.
2. Remove the drive plate using the drive plate
puller (597032-2621). Remove the shims from
the compressor drive plate or drive shaft.
3. Remove the snap ring using external snap
ring pliers.
4. Position the center pulley puller at the end of
the driveshaft.
5. Attach a suitable pulley puller to the pulley.
Hook the puller claws to the edge of the
pulley as shown.
6. Tighten the center pulley puller bolt to remove
the pulley.
CAUTION!
Do not clip the puller claws into the pulley
groove to prevent pulley groove damage.