Page 44
Installation Manual - SRF40
ENGLISH
GAS / ELECTRIC
6.1 Control Module Access
The fireplace is supplied with a User Interface wall box that must be installed in a standard plastic outlet
box (not provided). A low voltage orange or blue box is recommended. The user interface wall box
must be placed in the wall within ten feet from the right side of the fireplace. A 12 feet battery and user
interface extension wire harness is supplied.
The red and black battery extension harness is connected to the red and black mating connector pre-
installed on the control module. The mating connector can be located inside the fireplace near the gas valve.
Locate and install the provided wire grommet over the low-voltage battery and interface extension
harnesses at the right side of the fireplace. Snap the grommet into the hole in the side of the fireplace
just under the access panel opening.
Run the extension wiring to the user interface wall box and connect the white connector to the remote
receiver battery box. Install the battery box into the wall outlet box, then install the white remote cover
supplied with the provided screws.
VERTICAL
FRAMING
MEMBER
USER INTERFACE
HARNESS
USER INTERFACE/
BATTERY HOLDER
MUST BE INSTALLED
INTO WALL JUNCTION
BOX. (ORANGE LOW-
VOLTAGE BOX
RECOMMENDED.)
COMPONENT
ACCESS BOX
ELECTRICAL POWER TO UNIT
JUNCTION BOX / CONTROL MODULE
