2
947752
INSTALLATION
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case the
user will be required to correct the interference at
one’s own expense.
DIMENSIONS/WEIGHT
VIP-A12ADS
– 12.81” diameter x 7.00” depth
17.6” maximum extension from wall or ceiling
Weight: 11.00 lbs
VIP-A16ADS
– 16.81” diameter x 7.25” depth
21.6” maximum extension from wall or ceiling
Weight: 12.6 lbs
Nominal Power Requirements
802.3af PoE:
Class 3
Environment
Temperature:
0 to +45° C
Humidity:
0 to 85% non-precipitating
Packing List
Qty.
Item
2
12” or 16” Clocks
1
Network Interface
1
Double Sided Housing
1
VSP Document
Housing Assembly
MOUNTING/CONNECTIONS
A minimum of 18” (for the VIP-A12ADS) or 24
”
(for
the VIP-A16ADS) of network cable must extend from
the mounting location for connection to the RJ45 jack
on the Network Interface inside the clock housing.
A safety restraint cable (not included) is strongly
recommended to be installed in addition to the
mounting bracket attachment to the wall or ceiling.
Insert the cable through the back of the mounting
bracket, through the center support bracket, and out
the large center hole. Securely attach the end of the
safety restraint cable to one of the predrilled holes in
the center support bracket. The other end of the safety
restraint cable should be securely attached to the
building structure.
Remove the shipping screws holding the mounting
bracket to the clock housing. Insert the network cable
through the back of the mounting bracket, then attach
the bracket to a double gang outlet box using the four
inner holes on the mounting bracket. Use the four
outer mounting holes if attaching directly to a wall or
ceiling.
