Valcom VIP-997 Manual Download Page 4

Page: 4 / 4

4 947605

OR EQUAL

MOUNTING BRACKET CAN BE DIRECTLY ATTACHED TO WALL SURFACE OR ATTACHED TO THE APPROPRIATE OUTLET BOX

OUTLET

SCREW PAN HEAD 8-32 x 3/8

BOX

BELL 5333-0

FOR THE APPLICATION.

MOUNTING BRACKET

FROM PREVIOUS STEP. TAKE CAUTION NOT TO PINCH THE CABLES OR COUPLER.

GASKET

OUTDOOR

OR EQUAL

TIGHTEN FOR WATER TIGHT SEAL. SLIDE STROBE HOUSING OVER MOUNTING BRACKET, ALIGN HOLES AND REPLACE (4) 8-32 SCREWS

NOTE

NOTE:

REMOVE STROBE FROM PACKAGING. REMOVE (4) 8-32 SCREWS THAT HOLD THE MOUNTING BRACKET IN PLACE.

SAVE THE SCREWS TO RE-MOUNT THE STROBE TO THE MOUNTING BRACKET LATER.

SECURE THE MOUNTING BRACKET TO WALL WITH APPROPRIATE HARDWARE.

CONNECT CUSTOMER RJ45 CONNECTOR (POE)TO OUTDOOR COUPLER. MAKE SURE GASKETS ARE IN PLACE AND

INDOOR

OUTLET

BOX

RACO 683SP

SCREW PAN HEAD 6-32 x 5/8

FIGURE 1. INSTALLATION

Figure 3. Connecting to Outlet Box

Figure 4. Mounting to Wall

Summary of Contents for VIP-997

Page 1: ...er Requirements Via 802 3af PoE Ethernet Switch 6W Environment Temperature 40 to 70 C Humidity 0 to 85 non precipitating These products are intended for use with a UL Listed power source marked Class...

Page 2: ...ratus near water Ne pas utiliser cet appareil pr s de l eau 6 Clean only with dry cloth Nettoyer avec un chiffon sec 7 Do not block any ventilation openings Install in accordance with the manufacturer...

Page 3: ...port or via email at support valcom com When requesting assistance you should include all available information General information and troubleshooting procedures are available on the Valcom website a...

Page 4: ...TROBE HOUSING OVER MOUNTING BRACKET ALIGN HOLES AND REPLACE 4 8 32 SCREWS NOTE NOTE REMOVE STROBE FROM PACKAGING REMOVE 4 8 32 SCREWS THAT HOLD THE MOUNTING BRACKET IN PLACE SAVE THE SCREWS TO RE MOUN...