2 947494
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
Precautionary Designations
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated in
a commercial environment. This equipment
generates, uses and can radiate radio
frequency energy and if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment
in a residential area may cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
Mounting
The VIP-824A is designed for wall, table or rack
mounting.
Table:
Provided with the VIP-824A are four rubber
pads. Peel pads from their carrier backing and
place at the four corners of the bottom of the unit.
Wall
: Using the template on last page of this
document, mark the location of the bracket screw
holes on the wall. Drill 5/64" pilot holes, 3/4" deep,
at each screw location and use the wood screws
provided to attach the brackets to the wall. For
surfaces other than wood, use hardware
appropriate for the surface (not included). With the
brackets securely attached to the wall, attach the
VIP-824A to the brackets using the included
hardware. Figure 2 illustrates the bracket
assembly.
Rack:
Following the assembly drawing, attach the
two mounting brackets to the VIP-824A unit. Using
rack screws, mount the VIP-824A in an available
1U rack slot. See Figure 1.
Figure 1
Power Connections
The preferred method of powering a VIP-824A is
via a Power over Ethernet (PoE) switch meeting
the 802.3af specification.
If the rear panel barrel connector is used for power,
the preferred power supply is a Valcom VIP-324D.
Make all required signal connections before
applying power to the unit. If powering via 802.3af,
make sure all signal connections via the back
panel are made then connect the VIP-824A to the
Ethernet switch.
If power is supplied via the barrel connector, make
sure all signal connections are secure. Attach the
unit to the network via the front panel RJ-45
Ethernet connector. Apply power by plugging the
power supply into the VIP-824A via the barrel
connector on the rear of the VIP-824A.
Network Connection
The VIP-824A has one RJ-45 network connector
on the front panel.
Use a standard patch cable to connect the
VIP-824A to an Ethernet switch. If the Ethernet
switch is 802.3af compliant, the VIP-824A will draw
power from it.
Summary of Contents for VIP-824A
Page 4: ...4 947494...
