1
947490
Issue 3
VE8006R
IP ADMIN I/O MODULE
INTRODUCTION
The VE8006R IP Admin I/O Module allows most
loop start terminal devices to be connected to a
managed IP-based LAN/WAN. The VE8006R is
made specifically for rack mounting (1U).
SPECIFICATIONS
Access Methods
PBX, FXO Port
POTS telephone set
Features
RJ-45 for network connection
4 Relays with Form A contacts
Activity LED
Network activity LEDs
2 RENS
2.5mm jack for external power
Dimensions/Weight
1 Standard 19” Rack Unit
1.75” H x 16.50” W x 5.25” D
(4.45 cm x 41.91 cm x 13.33 cm)
Weight: 5.10 lbs. (2.32 kg)
Nominal Specifications
Input Impedance:
600 Ohms
Input Level:
-10dBm
Output Impedance:
600 Ohms
Output Level:
- 10dBm nominal
Relay Current:
1 AMP @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage:
24VDC
Current:
1 AMP
Power Supply Included
Environment
Temperature:
0 to +40° C
Humidity:
0 to 85% non-precipitating
These products are intended for use with a UL
Listed power source marked “Class 2” or “LPS”
rated 24VDC.
Precautionary Designations
WARNING
:
To Reduce The Risk Of Fire
Or Electric Shock. Do Not Expose This
Apparatus To Rain Or Moisture.
AVERTISSEMENT: Afin de réduire les
risques d'incendie ou de décharge
électrique, évitez d'exposer le système à
la pluie ou à l'humidité.
Apparatus shall not be exposed to
dripping or splashing and no objects
filled with liquids, such as vases, shall be
placed on the apparatus.
L’appareil ne doit pas être exposé à des
égouttements et éclaboussures et
aucun Objet Rempli de liquide, comme
vase, ne doit être placé sur l’appareil.
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VE8006R is not intended for direct
or indirect connection to the public telephone
network. When used with a customer premise
telephone system such as a key system or
PBX system, these units are interfaced to the
system via a fully protected system central
office port, which is a fully protected interface
device. Also, the host system must be
configured to disallow central office trunk
conferencing in order to prevent indirect
connection to the public network.
A detailed Programming manual is available
at www.ValcomES.com
