Valcom V-1013A, Installation Instructions, Page: 2 / 3

VALCOM ONE-WAY AMPLIFIED TRACK STYLE SPEAKERS
Valcom Track Style Speakers, V-1013A (one-watt) and V-1014A (five watt), are
weather resistant, self-amplified and provide voice paging as well as background
music. These speakers have externally accessible volume controls that are adjustable
by a screwdriver through the hole in the grille and are available in white, black, and
gray.
Model V-1013A-W White Model V-1014A-W
Model V-1013A-BK Black Model V-1014A-BK
Model V-1013A-GY Gray Model V-1014A-GY
DIMENSIONS/WEIGHT
•
V-1013A- 5.8”Dia x 10”H (14.73cm Dia. x 25.4cm H)
•
2.5 lbs. (1.14kg)
•
V-1014A- 5.8”Dia x 10”H (14.73cm Dia. x 25.4cm H)
•
3.1 lbs. (1.41kg)
The V-1013A requires -24VDC, 50 mA (1 Valcom Power Unit) and the
V-1014A requires -24VDC, 300 mA (6 Power Units).
The V-1013A and V-1014A are both FCC Part 68 Registered under
BAFUSA-69358-KX-N.
Note: Do not connect this speaker directly to a 25/70/100 volt amplifier
as damage to both the amplifier and speaker may occur.
INSTALLATION
1. Mount the bracket.
2.
Remove knobs and mount speaker to bracket.
3. Attach knobs and position at the desired angle. Tighten knobs. (See Figure 1).
Typical coverage of these speakers is 600 square feet with good quality paging
heard up to thirty feet in front of the speaker. Speakers should be spaced
approximately twenty feet apart. The five watt version is recommended for
higher noise level areas.
CONNECTIONS
Recommended Quantity of Speakers per Specific Power Run
Speakers per Power Run Wire Run Length (Ft.)
V-1013A V-1014A 24AWG 22AWG
15
7
3
2
1
0 250
500
1000
400
800
1600
TROUBLESHOOTING CHART
SYMPTOM ACTION
No audio from
speaker
Low volume from
speaker
Loud squeal
(feedback)
1. Verify volume control is turned up (clockwise).
2. Using a lineman's test set, check for proper audio
level at Tip and Ring leads and if necessary at the
source.
1. Verify volume control is turned up.
2. Check voltage at the speaker when in use, (-18 to
-24VDC required).
3. Using a lineman's test set, check for proper audio
level on Tip and Ring leads. It is possible that
some low level audio will be heard with only one
side of Tip and Ring connected.
1. Decrease volume of speaker (counterclockwise).
2. Increase the distance between telephone and
speaker.
3. Install confidencer on the telephone in severe
problem areas.
Knob
Mounting
Bracket
FIGURE 1
Volume
Control
(Tip/A) Green
(Ring/B) Red
(-24VDC) White
(GND) Black
One-Way
Amplified
Speaker Page
Out
Valcom Page
Control
Valcom -24VDC
Power Supply
FIGURE 2