background image

VALCOM SIGNATURE SERIES

TM 

, HIGH FIDELITY 

CEILING SPEAKER 

 

Valcom Signature Series

TM

 Ceiling Speaker, V-1420, is a high fidelity, self-

amplified (6 Watt amplifier) speaker and may be used to provide one-way 
paging and high quality music reproduction from any Valcom page control.  
This speaker has an adjustable volume control located on the front of the unit.   
The V-1420 required -24VDC, 200mA (4 Valcom power units).  The speaker is 
available in a white powder epoxy finish. 
 

NOTE: 

No power amplifier required.  Do not connect this speaker 
directly to a 25/70/100 Volt amplifier as damage to both 
the amplifier and speaker may occur.  (Recommended 
nominal input level to the V-1420 is -10dBm). 

 

MOUNTING CONNECTIONS 

Cut an 8.50" diameter hole in ceiling tile.  After connections have been made to 
the speaker, attach speaker to ceiling tile using the mounting hardware 
provided.  (A metal backbox with rails is available separately as model 
V-9816M). 
 

Typical Connections to a Valcom Page Adapter 

 

 

Recommended Quantity of Speakers per Specific Power Run 

(Standard Category 3 Twisted Pair Telephone Wire) 

SPEAKERS PER 

POWER RUN 

 

WIRE RUN LENGTH (FEET) 

V-1420

 

24AWG

 

22AWG

 

300 

500

 

500 

800

 

775 

1200 

 

FCC NOTICE 

NOTE:  The equipment has been tested and found to comply with the limits for 
Class A digital devices, pursuant to Part 15 of the FCC Rules.  These limits are 
designed to provide reasonable protection against harmful interference when 
the equipment is operated in a commercial environment.  This equipment 
generates, uses and can radiate radio frequency energy and if not installed and 
used in accordance with the instruction manual, may cause harmful 
interference to radio communications.  Operation of this equipment in a 
residential area is likely to cause harmful interference in which case the user 
will be required to correct the interference at his own expense. 
 
NOTE:  This unit was tested with shielded cables and peripheral devices.  
Shielded cables must be used with the unit to insure compliance. 
 
NOTE:  The manufacturer is not responsible for any radio or TV interference 
caused by unauthorized modifications to this equipment.  Such modifications 
could void the user’s authority to operate the equipment. 

 

TROUBLESHOOTING CHART 

SYMPTOMS

 

ACTIONS

 

No audio from 

speaker 

1.  Verify volume control is turned up (clockwise). 
2.  Using a lineman’s test set, check for proper audio level on 

Tip/A and Ring/B leads and if necessary at the source. 

Low volume 

from speaker 

1.  Verify volume control is turned up. 
2.  Check voltage at the speaker when in use (-18 to -24VDC 

required). 

3.  Using a lineman’s test set, check for proper audio level on 

Tip/A and Ring/B leads.  It is possible some low level audio 
will be heard with only one side of Tip/A and Ring/B 
connected. 

Loud squeal 

(feedback) 

1.  Decrease volume of speaker (counterclockwise). 
2.  Increase the distance between telephone and speaker. 
3.  Install confidencer on the telephone in severe problem areas. 

  Dimensions/Weight 

• 

13.00" Diameter x 3.00" D (33.02cm Diameter x 7.62cm D) 

• 

3.5 lbs. (1.59 kg) 

Valcom Page
     Control

Page
Out

V-1420
One Way
Amplified
Speaker

Tip/A
Ring/B
-24VDC
Gnd

2-pair twisted
telephone wire

Valcom -24VDC
Power Supply

FIGURE 1

Reviews: