FIGURE B
3. Align the back support bar with the corresponding tubes
of the seat back. Be sure the buttons on the support bar
face the same side as the corresponding holes on the
seat tube.
4. Insert the back support bar into the tube. Depress
each button while pushing down on the bar, inserting it
further into the seat tubes until the buttons pop into the
button holes on the housing.
NOTE: FOR SAFETY REASONS THE SUPPORT BAR IS A TIGHT
FIT AND YOU MAY NEED TO PUSH HARD TO SEAT THE BAR INTO
POSITION CORRECTLY
FIGURE C
5. Pull the fabric of the seat back up and over the back
support bar.
6.
Work the fabric
over the back support bar until it fits
snugly into position.
NOTE: THE FABRIC WILL BE A TIGHT FIT AND WILL REQUIRE
EFFORT TO FIT IN PLACE.
7. Pull the side armrest flaps over the metal frame and
secure with the snaps.
IMPORTANT WARNING: ALWAYS TEST THAT ALL BUCKLES,
SNAPS AND CLAMPS ARE SECURELY ENGAGED BEFORE USE.
JOEY ASSEMBLY/OPENING
FIGURE D
8. Remove Joey toddler seat from the carton and dispose
of any packaging thoughtfully.
9. Remove the bumper bar from the nylon housing at
either side of the stroller frame by pressing each inner
“release button” and pulling the bar upward (refer to
your stroller guide)
.
TO ATTACH THE SEAT
FIGURE E
10. Position the Joey toddler seat in the center of the
stroller and slot the clip foot over the front bar of the
stroller footrest. Be sure that the Joey seat faces forward
on the stroller.
11. Gently push down on the clip foot to secure the clip
foot onto the bar.
IMPORTANT WARNING: ALWAYS TEST THAT ALL BUCKLES/
CLAMPS ARE SECURELY ENGAGED BEFORE USE.
FIGURE C
12. Insert the bar ends into the nylon housing located on
either side of the frame. Be sure that the bar is securely
engaged in both sides.
E
B
C
!
!
D
2
