General Safety Requirements
Do not open the controller enclosure. There are no user-serviceable parts
inside, and you may cause a dangerous failure.
Do not replace the power entry module fuses with anything but 5 x 20 mm
250V 5A FAST BLOW fuses.
Do not make physical or electrical contact with the heater assembly
controlled by the ITC2 before disconnecting the ITC2 from its power source
and allowing adequate time for the heater to cool. The time required will
vary, depending on the heater mass.
Make sure that the heater voltage rating matches the power input voltage
rating of the power into which the ITC2 is connected
To prevent temperature runaways on new installations, after power up,
watch to see that the measured temperature begins to show a positive
movement upward. (This may take slightly longer for a large heated
mass.) If there is no increase, shut down everything and check the system
NOTE:
The product meets all current CE requirements for its intended application environment.
