36
37
EN
EN
Useful information
Useful information
C
C
C
Useful information
Problem
Possible causes
Solution
Foam in the tub
Improper detergent
• Use only the special
dishwasher detergent to
avoid suds. If this occurred,
open the dishwasher and
let suds evaporate. Add 1
gallon of cold water to the
tub. Close and latch the
dishwasher, then Start any
wash cycle to drain out the
water.
• Repeat if necessary.
Spilled rinse aid.
• Always wipe up rinse aid
spills immediately.
Stained tub interior
Detergent with colourant
may have been used.
• Make sure that the
detergent has no colourant.
White film on inside surface Hard water minerals.
• To clean the interior, use
the damp soft cloth with
dishwasher detergent and
wear rubber gloves. Never
use any other cleaner than
dishwasher detergent for
the risk of foaming or suds.
There are rust stains on
cutlery
The affected items are not
corrosion resistant.
• Avoid washing items that
are not corrosion resistant
in the dishwasher.
A program was not run after
dishwasher salt was added.
Traces of salt have gotten
into the wash cycle.
• Always run the quick
wash program. without any
crockery in the dishwasher
and without selecting the
Turbo function (if present),
after adding dishwasher
salt.
The lid of the softer is loose. • Check the lip. Ensure the
fix is fine.
Knocking noise in the wash
cabinet
The spray arm is knocking
against an item in a basket.
• Interrupt the program,
and rearrange the items
which are obstructing the
spray arm.
C
Useful information
Problem
Possible causes
Solution
Rattling noise in the wash
cabinet
Item of crockery are loose
in the wash cabinet.
• Interrupt the program,
and rearrange the items of
crockery.
Knocking noise in the water
pipes
This may be caused by
on-site installation or the
cross-section of the piping.
• This has no influence on
the dishwasher function. If
in doubt, contact a qualified
plumber.
The dishes are not clean
The dishes were not loaded
correctly.
• See "Preparing And
Loading Dishes".
The program was not
powerful enough.
• Select a more intensive
program.
Not enough detergent was
dispensed.
• Use more detergent, or
change your detergent.
Item are blocking the path
of spray arms.
• Rearrange the items so
that the spray can rotate
freely.
The filter combination in
the base of wash cabinet is
not clean or is not correctly
fitted. This may cause
the spray arm jets to get
blocked.
• Clean and/or fit the filter
correctly. Clean the spray
arm jets.
Cloudiness on glassware.
Combination of soft water
and too much detergent.
• Use less detergent if you
have soft water and select
a shorter cycle to wash the
glassware and to get them
clean.
Black or grey marks on
dishes
Aluminium utensils have
rubbed against dishes
• Use a mild abrasive
cleaner to eliminate those
marks.
Detergent left in dispenser
cups
Dishes block detergent
dispenser cups
• Re-loading the dishes
properly.
Summary of Contents for 6S49 F S929C
Page 2: ...1 2 3 4 5 6 A ...