Vaisala WAC151, User Manual, Page: 12 / 26

• Cable cutters
• Cable stripper
• Slothead screwdriver
1. Remove the four screws holding the cover of the junction box. Remove the cover.
2. Lead the sensor cable through the cable gland.
3. For better protection against RF interference, fold the braided cable shield over the
plastic sleeve.
4. Connect the wires to the line terminal inside the junction box. See Wiring wind sensors
WAA151 and WAV151 (page 13)
The wiring diagram inside the box is applicable only for WAA151 and WAV151
sensors with shaft heating.
5. Tighten the output cable glands.
6. Reattach the cover carefully with four screws.
Make sure that the gasket seals the junction box properly.
WAC151 User Guide M210349EN-C
10