Vaisala VERITEQ vNet, User Manual

Page: 10 / 38

4 VAISALA
Before you start:
• Obtain an IP address for each vNet Device from your IT
department. They should either be reserved IP addresses
supplied by DHCP, or static IP addresses (recommended). If
the IP addresses are reserved, the DHCP server must be
updated before you proceed with the installation.
• Write down the MAC address of the vNet Device (address is
found on the side of the vNet Device above the serial number).
• Modify Firewall settings:
• Allow the dgrunwiz.exe and dgcfgwiz.exe programs to
receive incoming network connections.
• Unblock UDP port 2362 and multi-cast address
224.0.5.128, as these are used by device discovery.
To install drivers for vNet Devices on the same subnet:
Note:
vNet Devices are installed with Digi Driver software
(all Setup Wizard screens refer to Digi Drivers).
1
Insert the Vaisala vNet and Digi Device Drivers CD into the
PC.
If the Software Installation menu does not display automati-
cally, click
Start
on the Taskbar, then select
Run
. Type
D:\setup.exe
(replace ‘
D
’ with the drive letter of your CD-
ROM drive), then click
OK
. The Software Installation window
displays.
2
To check for the most recent updates to the software
installation, click
Documentation Index
, then click
vNet PoE
Readme
.
3
In the
Software Installation
window, click
Device Setup
Wizard
, then connect the vNet Device to your network.
If the vNet Device and your network both support Power over
Ethernet, an external power supply is not needed. Otherwise,
connect the power supply barrel plug into the vNet Device
(see Figure 2 on page 3), and plug the power supply into a
wall outlet.
4
When the
Welcome to the Digi Device Setup Wizard
screen
displays , click
Next
.