Trailer hitch mounting with MD30REARKIT or
MD30REARMOUNT
To use MD30REARKIT or MD30REARMOUNT, you need:
•
Standard 50 mm (2.00 in) trailer hitch (ball) installed on your vehicle.
•
12 ... 24 VDC power input with a 2 A fuse.
Only licensed experts who have experience in vehicle electronics may install electrical
components. They must adhere to local and state legislation and regulations.
WARNING!
3-m (10 ft) open-ended power cable
BM10
MD30REARMOUNT
MD30
MD30REARMOUNT
MD30REARKIT
Figure 1 MD30REARKIT and MD30REARMOUNT contents
192 [7.57]
100 [3.94]
530 [20.86]
112 [4.39]
mm
[in]
Figure 2 Trailer hitch dimensions
The mechanism is fixed. You cannot adjust the length of the mounting frame.
When mounting MD30 on the rear, Vaisala recommends that you mount the air temperature and
humidity sensor HMP113 on the side of the vehicle away from exhaust gas and engine heat. For that
purpose, you can order MD30EXTSET. When using MD30REARKIT or MD30REARMOUNT with
MD30EXTSET:
•
Remove HMP113 from MD30.
•
Mount MD30REARKIT or MD30REARMOUNT.
•
Mount HMP113 as instructed in
Mounting Temperature Sensors Separately Installation Guide
.
M212520EN-A
Installation
Guide
Mounting MD30 on trailer hitch
Vaisala Mobile Detector MD30
PUBLISHED BY
Vaisala Oyj
Vanha Nurmijärventie 21
FI-01670 Vantaa, Finland
© Vaisala 2020
All rights reserved. Any logos and/or product names are trademarks of Vaisala or its individual partners.
Any reproduction, transfer, distribution or storage of information contained in this document is strictly
prohibited. All specifications — technical included — are subject to change without notice.
