User's Guide ______________________________________________________________________
142 _________________________________________________________________ M210667EN-C
To remove the measurement head cover, follow these instructions:
1.
Loosen the fastening screws carefully by a quarter
counterclockwise turn. Due to the included ejector the lock screws
will easily slide out from the associated receptacle.
2.
The measurement head cover has to be lifted up before it can be
removed from the support unit.
Closing Interface Units
When all wiring activities are finalized and the cable feed-throughs are
carefully tightened, the interface units can be closed.
The interface unit enclosure is equipped with two locks. The unit locks
are shown in Figure 98 below. A fitting key is part of the delivery.
0401-104
Figure 98
Interface Unit Locks
Mounting Interface Unit Covers
After the interface unit has been carefully closed, the interface unit
covers can be installed.
The lower interface unit cover (see Figure 99 on page 143) is to be
fastened with the four mushroom head screws which are part of the
delivery.