Vaisala HUMICAP HM44, User Manual, Page: 14 / 52

User's Guide _______________________________________________________________________
_________________________________________________________________________________ 12
Setting the probe type
In cases where an indicator (or a probe) is without an ID-marking, the following probe
numbers have to be selected:
Probe Probe setting
HMP41 1
HMP42 2
HMP44 1...10
HMP45 1
HMP46 2
•
change the setting with buttons
▲
and
▼
With the probe HMP44 there is no need to change the setting.
•
press ENTER; the display now changes to show the text START. Change this
setting only if there is no ID-marking on the indicator label. Otherwise do not
change this setting.
Select the function
In cases where an indicator (or a probe) is without an ID-marking on the label the following
function selection is made:
Probe Setting
HMP41
HMP42
HMP45
HMP46
Start 1
HMP44 Start 5
•
change the setting with buttons
▲
and
▼
•
press ENTER three times; the display now changes to show the following
settings (do not change them):
baud 4.8
seri E.7.1
calib def (*
(*
when entering the setting calib , the value is always ‘no’; the factory settings are
restored by selecting ‘def’. After this, the previously entered adjustment coefficients
are no longer valid.