Visit our Internet pages at
www.vaisala.com
Ref. M211557EN-A
ASSEMBLING THE HMT330WPA
1.
Bring the probes together as shown below. Insert the
screw sleeve (7) over the probes and connect them
together with the sealing rubber (6).
2.
Insert the first tube (5) over the probes and tighten it to
the screw sleeve (7). Insert the small white plastic
support (4) to the cable at the base of the RH
measurement probe. Route the cable of the T probe so it
rests in the cutout of the support. Push the screw sleeve
so that the support goes inside the tube.
3.
Tighten the RH measuring (3) tube over the warmed
probe. This is the tube with most holes on the sides.
4.
Insert the grommet (1) to the hole at the end of the
T measuring tube (2). Then push the temperature probe
through the grommet and tighten the tube.
MECHANICAL SUPPORT: CABLE CONDUIT
Connect the conduit to the PG 16 thread on the screw sleeve (7).
MECHANICAL SUPPORT: M8 THREADED BAR
To use a threaded bar as a support, first attach the flange (9) to
the screw sleeve (7) using the two M3 threaded bars (8). Use
threadlocking fluid to secure the bars. Then connect your
M8 threaded bar to the flange.
