Display/keypad commands ___________________________________________________________
Vaisala _________________________________________________________________________ 37
Scaling the analog outputs
Turn the transmitter's internal dip switch
CALIBRATION
ENABLED
/
DISABLED
to upward position (ON). Press button
C
on the display
cover and a text similar to the following appears:
Numbers on the second line indicate the low end scaling of channel 1
currently stored in the transmitter memory. The text S
ET
L
O
on the
lower left corner indicates that you can now change the low end
scaling with buttons
▲
and
▼
. Acknowledge the value with button
E
and a text similar to the following appears:
Numbers on the second line indicate the high end scaling of channel 1.
The text S
ET
H
I
on the lower left-hand corner indicates that you can
now change the high end scaling with buttons
▲
and
▼
.
Acknowledge with button
E.
If there is another channel available, the display shifts to the scaling
menu of channel 2. You can now scale the analog outputs for the
channel 2 in the same way as described above.
Press button
C
to exit the display command mode or continue by
selecting the output quantities. This menu starts automatically after the
scaling menu only if the
OUTPUT SELECTION
dip switches are on the
position
SPECIAL
(all up) from the beginning.
NOTE
Remember to restore the dip switch settings.
LO
