User's Guide ______________________________________________________________________
42 __________________________________________________________________ M210855EN-C
Analog Output Module
0703-058
Figure 22
Analog Output 1 module
Installation and Wiring
1.
Disconnect the power. In case the analog output module is installed
in the factory, continue with the step 4.
2.
To attach the module, open the barometer cover and fasten the
analog output module to the bottom of the housing on the module
slot 1 with four screws.
3.
Connect the flat cable between the analog output module and the
motherboard's pins MODULE 1.
4.
Take out the protective plug from the cable gland and thread the
wires.
5.
Connect the wires to the screw terminals marked with
Ch+
and
Ch-
.
6.
Select the current/voltage output by setting ON either of the
switches 1 or 2.
7.
Select the range by setting ON one of the switches 3...7.
8.
Connect the power.
9.
Select the quantity and scale the channel through the serial line or
display/keypad.
:
1
=
Flat cable pins
2
=
Screw terminals for signal line
3
=
DIP switches to select the output mode and range
