Vaillant VUW 246/5-3 (H-GB), Installation And Maintenance Instructions Manual

Page: 11 / 60

0020244995_04 ecoTEC pro Installation and maintenance instructions
11
4 Notes on the documentation
▶
Always observe all operating instructions enclosed with
the installation components.
▶
Store these instructions and all other applicable docu-
ments for further use.
These instructions apply only to:
Product article number
Article num-
ber Gas Council
Number
VUW 246/5-3 (H-GB)
ecoTEC pro 24 0010021836 47-044-88
VUW 286/5-3 (H-GB)
ecoTEC pro 28 0010021837 47-044-89
VUW 286/5-3 (P-GB)
ecoTEC pro 28 0010021838 47-044-90
5 Product description
5.1 CE marking
The CE marking shows that the products comply with the
basic requirements of the applicable directives as stated on
the declaration of conformity.
The declaration of conformity can be viewed at the manufac-
turer's site.
5.2 Energy Saving Trust Endorsed Products
Only the most energy efficient products can carry the
‘Energy Saving Trust Endorsed Product’ brandmark making
it easy for consumers to choose products that have met strict
energy performance criteria.
Available for: Boilers, Heating controls and chemical inhib-
itors, the Energy Saving Trust endorsed product brandmark
gives consumers confidence that a product will cost less to
run, help lower energy bills and reduce carbon emissions.
About the Energy Saving Trust
Energy Saving Trust is an independent and impartial organ-
isation that provides trusted energy saving advice to em-
power millions of people to lead affordable, low energy life-
styles. For more information visit energysavingtrust.org.uk
5.3 Hot Water Association
Vaillant is a full member of the Hot Water Association and
promotes the scheme in association with its cylinder range.
Details are available on the web site www.vaillant.co.uk
5.4 Information on the identification plate
The identification plate is mounted on the underside of the
product in the factory.
Information on the
data plate Meaning
Read the instructions.
VUW… Vaillant gas-fired wall-hung boiler for
heating and domestic hot water genera-
tion
..6/5-3 Gross calorific value power/product
generation equipment
ecoTEC pro Product designation
2H, G20
–
20 mbar
(2.0 kPa)
Gas group and gas connection pressure
as set at the factory
ww/yyyy Date of manufacture: Week/year
Cat. Permissible gas categories
Types Approved gas-fired units
PMS Permissible total overpressure in heating
mode
PMW Permissible total overpressure during
domestic hot water generation
T
max.
Max. flow temperature
ED 92/42 Current efficiency directive fulfilled with
4* rating
V Hz Mains voltage and mains frequency
W Max. electrical power consumption
IP IP rating
Heating mode
Domestic hot water generation
P Nominal heat output range
Q Heat input range
D Nominal domestic hot water draw-off rate
Barcode with serial number,
7th to 16th digit = product article number
Note
Make absolutely sure that the product is compat-
ible with the gas group at the installation site.