COMMISSIONING
20
4.2.2
Pulling in heating wire and installing feed terminal
Step 1
Required tools:
⚒
Marking tool
Assembly instructions:
1. Mark the position at which you intend to install a
heating feed terminal.
Step 2
Assembly instructions:
1. Drill a slotted hole at the previously marked posi-
tion and two lateral fixing holes as shown in the
illustration on the left. You are free to choose
which tools you use for this, but it is important
that the surfaces are neatly deburred and that
the inner running surfaces of the conductor rail
are not damaged.
NOTICE!
►
All cut and drilling surfaces must be smoothly de-
burred.
►
The inner running surface of the profile must not
be damaged --> Remove insulating profile before
cutting or drilling if necessary.
Step 3
Required tools:
⚒
Phillips screwdriver
Assembly instructions:
1. Fasten the safety blocks with screws as shown.
Step 4
Assembly instructions:
1. Carefully pull the heating wire into the profile.
Leave approx. 30 cm of heating wire protruding
from the feed opening to connect the feed termi-
nal.
