EVT-20 EVT-30
Interface board with
DONGLE
Interface board with
MICRO SD-CARD
Operating instruction
EVT-30 – MICRO SD-CARD
An EVT-30 micro sd-card is used for making the correct Interface board settings when an
EVT-30 sensor is replaced. Please make sure that serial number on both the micro sd-card
and the new EVT-30 sensor are identical.
For replacing the sensor we refer to our TIB-781-AL.
Please note that the power supply should
NOT
be connected to the interface board, when
changing the micro sd-card.
Please take necessary precautions to avoid personal injury.
STEP 1
Open EPC60 cabinet. Make sure the
power of the interface board is switched
off.
STEP 2
Open the interface board, by removing
topplate.
To do so, remove screws as on picture.
STEP 3
Remove the micro sd-card out of its slot.
A Slide the metal cover down
over the
PCB- board, just a little, in the arrow
direction.
B
After a
small click
, the cover will be
ejected
upwards.
C
Lift the cover
straight up
.
D
Slide
the micro sd-card out of the
cover.
Pay attention not to mix the old
and new micro sd-cards.
