Installation
Installation
4
5
Pull off the cover from the Holder.
Remove the nut, metal washer and
rubber washer from the bottom of
the threaded tube.
Insert the holder down through the
hole in the unit, make sure that the
rubber washer is against the top
surface.
From the underside slide the rubber
washer, metal washer and screw
on the nut (removed earlier) and
tighten.
CAUTION:
Do not over tighten the
nut as this may damage the unit.
Replace the cover.
Push the smaller end of the shower
hose down through the holder.
Nut
Metal washer
Rubber washer
Threaded tube
Rubber washer
Metal washer
Holder
Place a rubber washer into the
cone at the end of the hose and
screw in the handset.
Place the cone into the holder.
Connect the other end of the hose
to the supply, the unit comes
with an adaptor and washer if
necessary.
Cover
Shower
hose
Cone
Shower
hose
Washer
Washer
Adaptor
Handset
Shower
hose
Holder
Cover
Water supply
