8
9
From below push the top part of the rubber seal up through the hole in the bath.
Push the waste housing up into the seal and hold in place.
From inside the bath place the waste flange over the seal and secure in position using
the screw, do not over tighten as might damage the bath.
Slide the compression nut, washer and seal over the pipe, push the pipe fully into the
waste assembly, slide along the seal and washer and finally screw on the nut, hand
tight only. Push in the plug.
Decreasing the pipe length.
The pipe can be shortened by carefully cutting, removing any burrs. Ensure all
calculations are correct before cutåting the pipe. Finish by following the above procedure.
Plug adjustment
To adjust the opening and/or closing position of the plug.
With a flat screwdriver loosen the adjusting screw to the required position, tighten the
locking nut, and refit into the waste. Test, and readjust if necessary.
Plug
Seal
Locking nut
Adjusting screw
Waste screw
Waste flange
with seal
Seal
Compression
nut
Washer
Seal
Overflow/waste
assembly
Overflow pipe
Cable to pop up waste
Adjusting
screw
Locking nut
Installation - Pop-up waste
Installation - Extension cable
Cover
Operating lever
Cable collar
If the hole centre distance between the
overflow and waste hole are greater
than 700mm (see dimensions on
page 4), an extension kit, part number:
WG-7/8-CABLEEXT can be purchased
to increase the cable length.
Please follow the below procedure to
extend the length of the fitting.
Bath waste section
Remove the cover on the side of the bath
waste section.
Set the position of the operating lever where
the cable connects at 12 o’clock
Using a tool for leverage remove the
cable collar from the bath waste section
and carefully release the cable from the
operating lever.
Waste
Extension Kit
Extension cable
Junction box
Existing cable
