Assembly and installation 81389
The length of the overflow pipe can be adjusted by pulling apart or pushing together
the inner and outer overflow pipes.
Should you need to reduce the length even more, pull the outer overflow out of the
collet, cut both the outer overflow pipe and the inner overflow pipe to the required
length, remove any burrs and reassembly.
Ensure all calculations are correct before cutting pipes.
Remove the blanking plug(s) from the overflow assembly. Using PTFE tape fit the inlet
elbow(s).
Push the rubber seal onto the overflow/waste assembly, and from the outside hold in
place over the bath overflow hole.
Screw on the overflow housing, tighten with an allen key.
Caution:
do not overtighten as this may damage the parts and/or the bath.
Place the overflow fascia over the overflow housing, make sure the slots for the outlet
and overflow are on the underside. Tighten by screwing the grubscrew located on the
underside of the overflow fascia.
Connect to the supply pipe work.
Overflow/waste
assembly
Rubber seal
Overflow fascia
Inner overflow pipe
Inlet elbow
Inlet elbow
Overflow
housing
Allen key
Allen key socket
Outlet and
overflow slots
Outer overflow pipe
Collet
Assembly and installation 81389
Push the seal onto the waste assembly
From below push the assembly up under the hole in the bath, and hold in place.
From inside the bath screw the waste flange into the assembly and tighten by hand,
(do not over tighten as this may damage the parts and/or the bath).
Slide the compression nut, washer and seal over the pipe, push the pipe fully into the
waste assembly, slide along the seal and washer and finally screw on the nut, hand
tight only.
Screw on the plug.
Decreasing the pipe length.
The pipe can be shortened by carefully cutting, removing any burrs.
Ensure all calculations are correct before cutting the pipe.
Finish by following the above procedure.
Operation
Plug
Seal
Seal
Compression
nut
Washer
Seal
Overflow/waste
assembly
Overflow pipe
Waste flange
with seal
Push down again to close the plug.
Push down to open the plug.
