4
5
Installation
Installation
Place one of the rubber washers into the cone end of the hose and screw to
the handset.
Place the second rubber washer into the other end of the hose and attach it to
the mixer outlet.
Washer
Cone end
of hose
Handset
Washer
Nut end
of hose
Before installing your new mixer,
flush through the pipe work to ensure
removal of debris, turn off the water
supply.
Identify the left and right pillars
and position on the bath. From the
underside of the bath fit the rubber
washers and nuts. Temporarily hand
tighten the nuts (see right).
Push a filter/washer into both securing
nuts on the mixer. Position the mixer
onto the pillars, screw on the securing
nuts and tighten (see below).
From the underside, now tighten the
nuts to clamp the mixer to the bath.
CAUTION:
Do not over tighten the nuts
as this may damage the bath.
Connect the water supply to the
inlet pipes. The hot water should be
connected to the left hand pipe.
Cold Pillar
Hot Pillar
Hot Pillar
Cold Pillar
Filter/washer
Mixer
Securing nut
Securing nut
Filter/washer
Cold Pillar
Hot Pillar
Washers
Nuts
