6
7
Installation
Operation
Before installing your new mixer, flush through the pipework to ensure removal of
debris, turn off the water supply.
Ensure that the seal is in place underneath of the body.
Position the mixer on the bath. From the underside of the bath fit the rubber
washers and nuts. Tighten the nuts to clamp the mixer to the bath.
CAUTION:
Do not over tighten the nuts as this may damage the bath.
Connect the water supply to the inlet pipes. The hot water should be connected to
the left hand pipe and cold to the right.
Hot control
handle
Rubber
washer
Nut
Hot inlet
Cold inlet
Seal
Cold
Hot
Cold control
handle
Rubber
washer
Nut
Hot tap
- Turning the handle clockwise will increase the water temperature.
Cold tap
- Turning the handle anti-clockwise will decrease the water temperature.
