6
7
Installation
Operation
Before installing your new tap, flush
through the pipe work to ensure
removal of debris, turn off the water
supply.
Identify the tap, red (hot) left hand side
and blue (cold) right hand side.
Ensure the seal is in place in the base
of the tap.
Position the tap on the basin. From the
underside of the basin fit the rubber
washer and nut. Tighten the nut to
clamp the tap to the basin.
CAUTION:
Do not over tighten the nuts
as this may damage the basin.
Repeat for the other tap.
Connect the water supply to the
inlet pipes. The hot water should be
connected to the left hand tap and cold
to the right.
Control
handle
Rubber
washer
Nut
Cold
Hot
Seal
Hot tap
- Turning the handle clockwise
will increase the flow of water.
Cold tap
- Turning the handle anti-clockwise
will increase the flow of water.
