Vaderstad Rapid RDA 400S, Original Instructions Manual

Page: 27 / 138

RDA 400S
27.06.2011
ver.2
27
D
Keep the hydraulic lever on the tractor in the lowering position (
Note!
"Floating" position
must not be used) until the ram ("folding ram") is fully refilled, locking the wing sections in
the unfolded position. See “Figure 3.19”.
Figure 3.21
E Always drive forwards when the seed drill is lowered to its working position, to prevent the
seed coulters becoming clogged.
F Lower the tool bar to its working position.
G Undo the safety cotter pins of the bout markers.
3.7.2 Changing to transport position
A Switch off the low-lift function at the control box. Raise the seed drill to its top position. Note!
When the wing sections are being folded and unfolded, the mid section must always be in its
fully raised position.
B Fold the drill.
C Check whether the automatic locking devices engage.
D Check that front implements and trailing implements do not exceed the 3 metre transportation
width limit.
E Block the bout markers with the safety cotter pins.
Figure 3.19 Figure 3.20