Preparing the Tracking Lanyard for Use
You will need all the items from the box that the lanyard was shipped in:
n
Lanyard
n
USB charger
n
USB charging cable
n
Ferrite bead
1. Snap the ferrite bead onto the charger cable about 2
inches (5 cm) from the connector that plugs into the
lanyard.
Note:
To ensure compliance with FCC regulations, you
must install the ferrite bead as directed.
2. Make sure the recessed power switch is in the ON
position.
3. Plug the charger into a power source, and connect the charger cable.
4. Plug the charger cable into the lanyard.
5. Leave the lanyard connected to the charger until the medallion blinks only occasionally. Charging may
take several hours.
13
Installation Guide for the RoboTRAK Presenter Tracking System
