Installing the Camera Enclosure in a Finished Wall
Follow these steps if the drywall is in place.
Warning
Before cutting the opening for the camera enclosure, ensure that no wiring is present in or immediately
adjacent to the area that the camera enclosure will be set into. Cutting or drilling into electrical wiring can
cause electrical shock or fire, resulting in death, injury, and damage to the building.
Warning
Before cutting the opening for the camera enclosure, ensure that no pipes are present in or immediately
adjacent to the area that the camera enclosure will be set into. Cutting or drilling into gas pipes can cause
explosion or fire, resulting in death, injury, and damage to the building. Cutting or drilling into water or
wastewater lines can result in injury and damage to the building.
1. Verify that no pipes or wiring pass through or immediately adjacent to the part of the wall where the
camera enclosure will be mounted.
2. Level, measure, and mark the cutting lines for the opening.
3. Cut the opening.
4. Slide the drywall clips into the corners of the enclosure.
Note
Although the drywall clips are not visually symmetrical, they can be installed with either curved surface
facing forward, depending on the corner in which they are placed.
5. Install the side brackets using 1/4 in. 6-32 screws.
6. Route the camera cable into the enclosure.
7. Slide the enclosure into place.
8. Use the 10-32 screws to attach the drywall clips to the side brackets. The clips tilt outward and engage
the drywall as you tighten the screws.
11
Installation Guide for the RoboSHOT IW Architectural PTZ Conferencing Camera
