EasyTalk Wireless Mic
EasyTalk Wireless USB Mic System - Document Number 342-0442 Rev A
Page 6 of 16
Table: Dip Switch Settings and Descriptions
Dip Switch 1 - Compressor:
Enable adds a Dynamic Range Compressor for the Audio Line Level Outputs
(balanced or unbalanced). Disable turns it off.
Dip Switch 2 - Speaker EQ Filter:
Enable adds a specialized output filter for improved intelligibility for voice
applications. Disable turns it off.
Dip Switch 3 - ON Position/USB Conference Mode:
Enable (Dip Switch 3 On)
creates the desired audio
mixing (Near and Far ends) for USB conferencing applications such as Skype, Jabber, Lync etc… In the USB
Conference Mode, the PC USB Speaker Audio is sent to the balanced and unbalanced audio line outputs,
which allows the Far End Audio to be presented in the room. The Belt Pack Wireless Microphone Audio is
also sent to the PC and the Far End. The EasyTalk Wireless Receiver will also be recognized as a USB
Audio Device by the PC with recording (the Belt Pack Wireless Microphone Audio) and playback (the Speaker
Audio) capabilities. Disable turns the USB Conference Mode off.
Dip Switch 3 - OFF Position/USB Record Mode:
Disable (Dip Switch 3 Off)
creates a USB Record Mode
for PC Audio Recording (PC requires Audio Recording Software-not included) and Playback through the USB
port (Audio output through the Balanced or Unbalanced Audio Line Outputs). The EasyTalk Wireless
Receiver will be recognized as a USB Audio Device by the PC with recording (the Belt Pack Wireless
Microphone Audio) and playback (the Speaker Audio) capabilities.
Dip Switch 4 - Radio ON/OFF:
ON enables the Radio Receiver for the Wireless Microphone. OFF turns it
off, naturally.
Dip Switch 5 - Baud Rate Selection ON/OFF:
OFF sets the Baud Rate to the default 9600bps. ON sets the
Baud Rate to 38400bps. For most applications 9600bps will do.
Dip Switch 6 - Front Panel Buttons Lock ON/OFF:
ON locks the Front Panel Buttons and disables the
buttons from functioning. OFF allows the front panel buttons to be used.
Dip Switch 7 - Software Control ON/OFF:
When ON, dip switches 1, 2, 3, 4, and 8 are ignored to allow full
serial control of the audio interface.
Dip Switch 8 - Resets to Factory Defaults ON/OFF:
When ON and power is plugged in, the interface is set
to factory defaults. Leave OFF for normal operation.
Dip Switch #
Function
1
ON/OFF - Enable/Disable - Compressor for the Balanced and Unbalanced Audio Outputs
2
ON/OFF - Enable/Disable - Speaker EQ Filter
3
ON/OFF - USB Conference Mode (Skype-type PC applications)
4
ON/OFF - ON Enables Radio, OFF Disables Radio
5
ON/OFF - Baud Rate Selection: 9600-Off/38.4K-On (Use 9600bps for most all applications)
6
ON/OFF - Front Panel Locked Out when ON
7
ON/OFF - ON allows full Serial control bypassing dip switches 1, 2, 3, 4, and 8
8 Not
Used
