Status Light
The light in the camera's base indicates its current state.
n
Blue – Camera is active
n
Purple – Standby mode or booting
n
Yellow – Firmware update is in progress
n
Blinking blue – USB cable is disconnected
n
Blinking purple – Error
Caution
Do not remove power or reset the camera while the indicator is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
The camera may be powered up and sending video even if the status light is off.
Restoring Default Camera Settings
Factory reset clears most settings and returns soft DIP switches (on the DIP Switches tab of the System
page) to their default positions.
Using the switches on the back of the camera:
Set all DIP switches DOWN and cycle the power to
reload the default camera settings. Then return all DIP switches to the desired settings.
From the web interface:
Log on using the admin account, go to the System page's Firmware tab, and
click Restore Factory Settings.
48
Integrator's Complete Guide to the ConferenceSHOT FX USB 3.0 Fixed Camera
