Testing Triggers
C
ONTROL
D
EVICES PAGE
The Trigger Testing section is available from both tabs of the Control Devices page. Trigger indicators
illuminate to show that the trigger is on.
To test a trigger:
1. Set Test Mode on.
2. Select the trigger to turn on.
3. Select the trigger again to turn it off.
Note
Turn off Test Mode when you are finished testing; otherwise, the triggers are not available to the control
device. Diagnostic: If you send a
trigger
command via Telnet and the command returns an error
message, check to see whether Test Mode is on.
38
Integrator's Complete Guide to the ConferenceSHOT AV Enterprise-Class Conferencing System
